Matrix User Guide
RINS915-2 Page: 25
5.2 Entering User Mode
For functions such as viewing the log, changing user codes and changing the time etc. you must first enter user
mode. If hidden display mode is enabled, you must exit this before entering user mode. This ensures system
information cannot be changed or viewed by unauthorised users.
Icon Keypad LCD Keypad
You can only enter user mode if one or more of your
assigned partitions are disarmed.
Enter TUV
If your code has been accepted you will hear a
confirmation tone, the disarmed icon (ã) will flash
and the OK icon (y) will extinguish. This indicates
that you are in user mode.
Once in user mode you can select the user mode
functions as described below.
Note: If you enter user mode and fail to
press any key for a while, user mode will
expire and the keypad will return to day
mode.
This timeout period is 20 seconds if hidden
display mode is enabled and 2 minutes if
hidden display mode is not enabled.
To enter User mode press once and enter your
user code
. If you do not wish to enter
the user menu, press the key again. Pressing this
key multiple times toggles entry to the user menu.
An acceptance tone will be heard and the following
display will be shown:
Note: If you enter user mode and use no
functions, the panel will automatically
time out and exit the user menu.
The time out period is 20 seconds if hidden
display mode is enabled, and 2 minutes if
hidden display mode is not enabled.
5.3 Exiting User Mode
Icon Keypad LCD Keypad
To exit the User mode, press . The disarmed
icon (ã) will stop flashing and the OK icon (y) will
re-appear.
There are two methods of exiting user mode:
1. Scroll to the end of the main user menu using the
key.
The following screen will be displayed:
Press to exit user menu
2. Whilst in user menu hold the key down for 2
seconds, which automatically exits user mode.
However this does not work whilst you are inside a
user function.
To Next Page
Loading...
Need help?
General
