Matrix User Guide
Page 42 RINS915-2
5.15 Adding/Removing Proximity Cards & Tags
Note: For a user to add proximity cards to the system the installer must first configure
user attributes.
Icon Keypad LCD Keypad
Adding Proximity Cards & Tags
Enter U
Enter the two digit user number ( - UT), you
wish to assign to this card/tag OR use the >and ?
keys to locate a valid user number (followed by the
key).
Present the card/tag at the reader and wait for a
single beep. Remove the card.
If a low error tone is heard then the card is already
programmed into the system elsewhere. Present
another card OR press the key to exit this function.
If programming was successful an acceptance tone
will be played. The function will drop back to user
menu mode.
Removing Proximity Cards & Tags
Enter user mode.
Enter U
Enter the two digit user number ( - UT ), you
wish to assign to this card/tag OR use the >and ?
keys to locate a valid user number (followed by the
key).
To remove the card from this user press the > key
once. An acceptance tone will be played and you will
be returned to user menu mode.
Use the
and
keys to navigate to “PROXIMITY
CARDS”. The following display will be shown:
Press to select this option.
The following display will be shown:
Use the
and
keys to select the you wish to
be associated with the card then press B.
The following screen will be displayed.
Note: Pressing
at this point will return
you to the main menu.
To remove the currently programmed card from the
selected user press , you will be returned to the
main menu.
To add a card, present the card to the reader. The
keypad will emit an acceptance tone if programming
was successful.
An error tone will sound if the card is programmed
elsewhere on the system, present another card or
press to return to the main menu.
To Next Page
Loading...
Need help?
General
