Qlogic QConvergeConsole 2400 Series User Manual

1–System Requirements
Software Requirements
1-2 SN0054669-00 C
The minimum hardware requirements for the server agent are as follows:
 Adapters. One or more of the QLogic adapters listed under “Supported
QLogic Adapters” on page 1-4.
The minimum requirements for a SAN environment are as follows:
 Storage. Fibre Channel or iSCSI devices, such as disks and RAID
subsystems. QConvergeConsole supports most Fibre Channel and iSCSI
devices. See the QLogic Storage Networking Interoperability Guide, which
you can download from the following QLogic Web page:
http://connect.qlogic.com/interopguide/info.asp
Software Requirements
The software requirements are as follows:
 Server on which your adapter is physically installed requires:
 QLogic adapter drivers for your operating system
 QLogic adapter management agents for your operating system
 TCP/IP protocol for Windows remote management
 Administrative privileges to perform management functions
 The ability to run the agent service (qlremote, iqlremote, and
netqlremote) on Windows 2008, requires that you disable user access
control.
 Port 8443 for the SSL connection.
 Apache Tomcat application server requires:
 Apache Tomcat (installed automatically by QConvergeConsole if not
already present)
 QConvergeConsole (before installing, refer to the Note on page 2-1)
NOTE:
Refer to the QLogic Web site for QLogic adapter drivers and agents:
http://driverdownloads.qlogic.com
.

Qlogic QConvergeConsole 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole 2400 Series
Category	Network Accessory
Language	English