Preface
What’s in the Help System
viii SN0054669-00 C
What’s in the Help System
For detailed information on configuring and managing adapters using
QConvergeConsole, refer to the built-in help system. The QConvergeConsole
help system contains features and functionality not covered in this guide, including
the following:
Getting Started shows how to start using QConvergeConsole and the help
system. It also describes how to initiate automatic e-mail notifications and
set security on adapters installed for a selected host.
Managing Host Connections describes how to connect to a host, create
and use a host group, view host information, and disconnect from one or
more host servers.
Displaying Host and Adapter Information describes how to view general
host and adapter information.
Displaying Device Information shows how to view information about a
device (disk or tape).
Using Reports describes the different types of reports and how to generate,
view, and save them using QConvergeConsole's report facility.
Managing Fibre Channel and Converged Network Adapter (FCoE)
Ports describes how to do the following:
View and configure common parameters for Fibre Channel and FCoE
ports on either Fibre Channel or Converged Network Adapters.
Use the advanced utilities, create and delete virtual ports, and run
diagnostics.
View the parameters and statistics for FCoE ports on 8100 and 8200
Series Converged Network Adapters.
Managing 8100 and 8200 Series Converged Network Adapter (FCoE)
Ports describes how to view the parameters and statistics for FCoE ports on
8100 and 8200 Series Converged Network Adapters.
Managing Converged Network Adapter (iSCSI) Ports shows and
describes the parameters provided on the iSCSI port management pages for
the 8200 Series Converged Network Adapters.
NOTE:
To access help, see “Getting Help” on page 3-3.
To Next Page
Loading...
Need help?
General
