A – Command Line Interface
Reset Command
A-32 59226-00 B
S
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Activates the pending firmware.
Closes all management sessions.
Clears the event log. To save the event log before resetting, refer to the “Set
Log Command” on page A-51.
To reset the switch with a power-on self test, refer to the “Hardreset Command” on
page A-19. To reset the switch without disrupting traffic, refer to the “Hotreset
Command” on page A-22.
system
Resets the system configuration settings to the factory default values. Refer to
Table A-8 for system configuration default values.
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.
Notes The following tables specify the various factory default settings:
NOTE: Because this keyword changes network parameters, the
workstation could lose communication with the switch.
Table A-3. Switch Configuration Defaults
Parameter Default
Admin State Online
Broadcast Enabled True
InbandEnabled True
FDMIEnabled True
FDMIEntries 1000
Domain ID 1 (0x Hex)
Domain ID Lock False
Symbolic Name SANbox
R_A_TOV 10000
E_D_TOV 2000
To Next Page
Loading...
Need help?
General
