Quantum FIREBALL PLUS AS 10.2 User Manual

Installation
3-4 Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0 GB AT
3.3
3.33.3
3.3 HARDWARE OPTIONS
HARDWARE OPTIONSHARDWARE OPTIONS
HARDWARE OPTIONS
The configuration of a Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0 GB
AT hard disk drive depends on the host system in which it is to be installed. This
section describes the hardware options that you must take into account prior to
installation. Figure 3-4 shows the printed circuit board (PCB) assembly,
indicating the jumpers that control some of these options.
Figure 3-4
Figure 3-4 Figure 3-4
Figure 3-4
Jumper Locations for the Quantum Fireball Plus AS Hard Disk Drive
Figure 3-5
Figure 3-5 Figure 3-5
Figure 3-5 Jumper Locations on the Interface Connector
DC Power
Connector
Jumpers
ATA-Bus
Interface
Header
Back of
Drive
Front
Drive

Quantum FIREBALL PLUS AS 10.2 Specifications

General

Brand	Quantum
Model	FIREBALL PLUS AS 10.2
Category	Storage
Language	English