Quantum FIREBALL PLUS AS 10.2 User Manual

Installation
Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0 GB AT 3-9
3.5
3.53.5
3.5 MOUNTING
MOUNTINGMOUNTING
MOUNTING
Drive mounting orientation, clearance, and ventilation requirements are
described in the following subsections.
3.5.1
3.5.13.5.1
3.5.1 Orientation
OrientationOrientation
Orientation
The mounting holes on the Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0
GB AT hard disk drives allow the drive to be mounted in any orientation. Figure
3-6 and Figure 3-7 show the location of the three mounting holes on each side of
the drive. The drive can also be mounted using the four mounting hole locations
on the PCB side of the drive.
Note: It is highly recommended that the drive is hard mounted on to
the chassis of the system being used for general operation, as
well as for test purposes. Failure to hard mount the drive can
result in erroneous errors during testing.
Drives can be mounted in any orientation. Normal position is
with the PCB facing down.
All dimensions are in millimeters. For mounting, #6-32 UNC screws are
recommended.
Figure 3-7
Figure 3-7 Figure 3-7
Figure 3-7
Mounting Dimensions for the Quantum Fireball Plus AS Hard Disk Drives

Quantum FIREBALL PLUS AS 10.2 Specifications

General

Brand	Quantum
Model	FIREBALL PLUS AS 10.2
Category	Storage
Language	English