Quantum FIREBALL PLUS AS 10.2 User Manual

Installation
Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0 GB AT 3-11
3.5.2
3.5.23.5.2
3.5.2 Clearance
ClearanceClearance
Clearance
Clearance from the drive to any other surface (except mounting surfaces) must be
a minimum of 1.25 mm (0.05 inches).
3.5.3
3.5.33.5.3
3.5.3 Ventilation
VentilationVentilation
Ventilation
The Quantum Fireball Plus AS 10.2/20.5/30.0/40.0/60.0 GB AT hard disk drives
operate without a cooling fan, provided the ambient air temperature does not
exceed 131°F (55°C) at any point along the drive form factor envelope.
3.6
3.63.6
3.6 COMBINATION CONNECTOR (J1)
COMBINATION CONNECTOR (J1)COMBINATION CONNECTOR (J1)
COMBINATION CONNECTOR (J1)
J1 is a three-in-one combination connector. The drive’s DC power can be applied
to section A. The ATA bus interface (40-pin) uses section C. The connector is
mounted on the back edge of the printed-circuit board (PCB), as shown in Figure
3-9.
Figure 3-9
Figure 3-9 Figure 3-9
Figure 3-9
J1 DC Power and ATA Bus Combination Connector
4321
4-Pin DC Power
(J1 Section A)
40-Pin IDE
(J1 Section C)
J1 IDE (40-Pin)/DC (4-Pin)
Combination Connector
Pin 1
Pin 40

Quantum FIREBALL PLUS AS 10.2 Specifications

General

Brand	Quantum
Model	FIREBALL PLUS AS 10.2
Category	Storage
Language	English