12. PRINTOUTS
Printouts menu is dedicated for creating non-standard printout templates and selecting
type of a printout which is printed. Detailed description of non-standard printouts is
provided in point 17 of this user manual.
13. SETTING ACCESSIBILITY OF MEASURING UNITS
All measuring units which attribute is set to 1: yes
are accessible from the main menu level under a key for toggling between the measuring
units.
The measuring units described as 09 Taele Hk., 10 Taele S., 11 Taele T . the following
relations occur:
• If the attribute of all three measuring units is set to 1: yes, then the software will
display only the first one, i.e. 09 Taele Hk
If the measurement should be carried out using 11 Taele T unit, then the attribute
of the other two units should be set to 0 : no
Enter group of parameters P7 Units in accordance with point 5.2.7.
Fig. 25. Measuring units - settings
After setting the required parameter values return to weighing mode in accordance with
point 5.1.2. of this user manual.
Caution:
In case of verified balances the available measuring units are limited to: [g], [mg], [ct] –
even if set to 1 – YES in balance’s menu.
To Next Page
Loading...
Need help?
General
