R&S FPC Series User Manual

Remote Control
R&S
®
FPC
273User Manual 1178.4130.02 ─ 07
CALCulate<n>:DELTamarker<m>:MINimum[:PEAK]
This command positions a delta marker on the current trace minimum.
If the delta marker is not active yet, the command also turns on that delta marker.
Suffix:
<n>
.
irrelevant
<m> Marker
Example: //Move delta marker 3 to the trace minimum
CALC:DELT3:MIN
Usage: Event
Manual operation: See "Set To Minimum" on page 376
See "Set To Minimum" on page 386
See "Set To Minimum" on page 404
CALCulate<n>:DELTamarker<m>[:STATe]
<State>
This command turns delta markers on and off.
Suffix:
<n>
.
irrelevant
<m> Marker
If you set the suffix at DELTamarker to 1, or use no suffix, the
R&S FPC interprets this as delta marker 2 because the first
marker has to be a normal marker. If more than one normal
marker (2 to 6) is already active, the command turns these
markers into delta markers. If no delta marker is active yet, the
command activates the delta marker and positions it on the trace
maximum.
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Turn on delta marker 3 or turn marker 3 into a delta marker.
CALC:DELT3 ON
Manual operation: See "Marker <x>" on page 374
See "Marker <x>" on page 384
See "Marker <x>" on page 395
See "Marker <x>" on page 403
CALCulate<n>:DELTamarker<m>:X <Position>
This command positions a delta marker on a certain coordinate on the x-axis.
Note that it is possible to place the marker outside the visible trace. In that case, this
value is invalid.
Remote Commands of the Spectrum Application

R&S FPC Series Specifications

General

Brand	R&S
Model	FPC Series
Category	Measuring Instruments
Language	English