ST80 Maxiview Operation and Setup10
Chapter 2: Operation
2.1 General
The Maxiview operates around a chapter and page principle –
chapters are independent sections: speed, depth, wind, etc., and
pages data related to that chapter.
When the Maxiview is powered up for the first time, the unit
defaults to the SAIL configuration, unless a POWER configuration
is received via SeaTalk (refer to the Masterview setup chapter).
Operating the Maxiview using the Remote Keypad
To operate the Maxiview using the Remote Keypad, you must first
carry out the setup procedures covered in the ST80 Remote Keypad
setup chapter.
Note: SeaTalk data must be available for a chapter to function. For
example, if speed data is lost for 8 seconds, the speed chapter is
replaced by a warning screen.
Keypad Beeps
• The keypad beeps once every time a key is pressed.
• An incorrect key sequence causes the Maxiview to beep a further 2
times.
Gaining Control of the Maxiview
• In order to make changes to the Maxiview displays, you must gain
control of the required Maxiview.
• Control is confirmed by the display changing to reverse video.
To Next Page
Loading...
Need help?
General
