Chapter 4: Installing the SportPilot 31
4 Installing the SportPilot
Mounting the sensor
1. With the steering amidships, align the sensor as shown in the
relevant illustration below:
Single drive system with horizontal steering arm
Single drive system with vertical steering arm
2. Use the three self-tapping screws to attach the sensor directly to
the transom (or a fabricated mounting base).
3. Remove the pin securing the steering arm to the power steering.
4. Fit the Raymarine steering pin and retain with a split/cotter pin.
D
1707-2
Parallel
Distance apart: 75 mm (3 in) min
310 mm (12.2 in) max
Rudder position
sensor
Sensor pin must
be level with
steering pin
Drive aperture
Raymarine steering pin
Steering arm
UP
D
1692-2
Parallel
Distance apart: 75 mm (3 in) min
310 mm (12.2 in) max
Rudder position
sensor
Steering arm
Sensor pin and
steering linkage
must be at
same height
Power
steering
UP
To Next Page
Loading...
Need help?
General