42 SportPilot and SportPilot Plus - Owner’s Handbook
4 Installing the SportPilot
Step 2 – Mount the torque bracket
1.
3
/
4
inch (19 mm) steering shafts only: assemble the supplied
adaptor collar (5) to the shaft. Align the slot in the collar with the
slot in the steering shaft.
.
2. Temporarily assemble the front of the torque restraint to the back
of the torque restraint.
3. Fit, but do NOT tighten, the washer and bolt to hold the front and
back of the torque restraint together.
Note: The torque restraint will not operate properly if the front and
back are not assembled correctly. Therefore, once you have
assembled the component parts, close the torque restraint as far as it
will go. If you have assembled it correctly, the front will lay flat
against the back.
D1364-3
Adaptor collar Woodruff key
Torque restraint
(front)
Torque restraint
(back)
Washer
D1525-2
Bolt
To Next Page
Loading...
Need help?
General