Chapter 4: Installing the SportPilot 41
4 Installing the SportPilot
4.6 Installing the SportPilot
Step 1 – Remove the steering wheel
1. Turn the wheel all the way over to starboard lock. You
MUST do this so you can tighten the retaining nut at the end of
installation (see page 48) without damaging the SportPilot.
2. Remove the steering wheel hub.
3. Holding the steering wheel still, use a suitable socket or the
supplied box spanner to remove the retaining nut and washer.
4. Carefully remove the steering wheel.
5. Remove the original woodruff key. Retain the woodruff key as
you will need to use it during a later stage of installation.
D1355-2
137.5 mm (5.4 in)
238.5 mm (9.4 in)
100.5 mm (4.0 in)
220 mm (8.7 in)
Woodruff
key
D1363-2
Steering
wheel hub
Retaining
nut
Washer
To Next Page
Loading...
Need help?
General