Renesas e1 User Manual

E1/E20/E2/E2 Lite Additional Document 2. Designing the User System
R20UT2937EJ0301 Rev.3.01 Page 13 of 45
Jul 1, 2020
2. Designing the User System
2.1 Connecting the E1/E20/E2/E2 Lite to the User System
To connect the E1/E20/E2/E2 Lite to the user system, a connector for the user system interface cable
must be mounted on the user system.
When designing the user system, read this section of this manual and the hardware manual for the MCU
in use.
2.2 Installing the Connector on the User System
Table 2-1 shows the recommended connectors for the E1/E20/E2/E2 Lite.
Table 2-1 Recommended Connectors
Connector
Type Number
Manufacturer
Specifications
14-pin
connector
7614-6002
3M Japan Limited
14-pin straight type (Japan)
2514-6002 3M Limited 14-pin straight type (other countries)
Note: Connection to the 38-pin connector of the E20 is not supported. To use the E20, use the 38-pin to 14-pin
conversion adapter that comes with the E20 for connection to the 14-pin connector on the user system.
2.2.1 Connecting the User System Interface Cable to the 14-Pin Connector
The following figures show how to connect the user system interface cable to the 14-pin connector of
each emulator.
E1/E2 Lite: Figure 2-1 (Connecting the User System Interface Cable to the 14-Pin Connector of the
E1/E2 Lite Emulator)
E20: Figure 2-2 (Connecting the User System Interface Cable to the 14-Pin Connector of the E20
Emulator)
E2: Figure 2-3 (Connecting the User System Interface Cable to the 14-Pin Connector of the E2
Emulator)
14-pin us
er-system interface cable
14-
pin connector
7614-60
02 or
2514-60
02
User system
Pin 1
Pin 2
Figure 2-1 Connecting the User System Interface Cable to the 14-Pin Connector of the E1/E2 Lite
Emulator

Renesas e1 Specifications

General

Brand	Renesas
Model	e1
Category	Computer Hardware
Language	English