Renishaw ATOM User Manual

47
www.renishaw.com
Restoring factory defaults
When realigning the readhead, reinstalling the system, or in the case of continued calibration failure, factory defaults should be restored.
To restore factory defaults:
• Switch the system off, then switch on again using the following methods depending on interface used.
• The readhead set-up LED will ash blue four times on switch on.
• Release CAL button, CAL pads link or CAL pin ground.
• Check the readhead mounting / installation and recalibrate the system.
Switching Automatic Gain Control (AGC) on or off
AGC can be switched on or off via the interface or the CAL line.
• The readhead set-up LED will be green with the addition of blue when AGC is enabled.
No interface ACi interface Ri interface Ti interface
Ground and hold the CAL pin
whilst switching the system on.
Connect the CAL pads
together or ground the
remote CAL line (pin8) whilst
switching the system on.
Press and hold the CAL button
on the side of the interface
whilst switching the system on.
Press and hold the CAL button
on the end of the interface whilst
switching the system on.
No interface ACi interface Ri interface Ti interface
Ground the CAL pin for
>3seconds then remove
ground link.
Connect the CAL pads together or
ground the remote CAL line (pin8)
for >3seconds then disconnect.
Press and hold the CAL button
on the side of the interface for
>3seconds then release.
Press and hold the CAL button
on the end of the interface for
>3seconds then release.
NOTE: The system must be calibrated before switching AGC on.
NOTE: System must be recalibrated after restoring factory defaults.

Renishaw ATOM Specifications

General

Brand	Renishaw
Model	ATOM
Category	Media Converter
Language	English