• When loading thick paper, thin paper, or OHP transparencies, set paper size and paper type.
• [Auto Detect] is the default setting for [Printer Bypass Paper Size].
• For details about setting printer drivers, see the printer driver Help.
• p.109 "Printer Features"
Setting Custom Size Paper Using the Control Panel
Follow the procedure below to set the machine using the control panel when loading custom size paper
onto the bypass tray.
• The following procedures are not required if you select [Driver/Command] from [Bypass Tray Priority]
in [System] of [Printer Features] (see "Printer Features"). In that case, set the paper size using the printer
driver.
• If you select [Machine Settings] from [Bypass Tray Priority] in [System] of [Printer Features] (see "Printer
Features"), the settings made using the control panel have priority over the printer driver settings.
• If the printer driver is not used, select [Machine Settings] from [Bypass Tray Priority] in [System] of
[Printer Features] (see "Printer Features"). Set paper size using the control panel.
1. Press the [User Tools/Counter] key on the control panel.
2. Press the [ ] or [ ] key to select [System Settings], and then press the [OK] key.
16
To Next Page
Loading...
Need help?
General
