14
Setting the Paper Size Using the Control Panel
Follow the procedure below to set the machine using the control panel when
loading standard size paper onto the bypass tray.
Important
❒
The following procedures are not required if you select
[
Driver / Command
]
from
[
Bypass Tray Setting Priority
]
in
[
System
]
of
[
Printer Features
]
(see “Printer Features”,
General Settings Guide). In that case, set the paper size using the printer driver.
❒ Under [Printer Features], [System], if you set [Bypass Tray Setting Priority] to
[Driver / Command] , paper size settings made on the printer driver must match
those made on the control panel. If they do not match, an error message ap-
pears and printing stops if [Printer Features], [System], [Auto Continue] is not
set. For details about [Printer Features] settings, see General Settings Guide.
A Press the {User Tools/Counter} key on the control panel.
B Press [System Settings].
C Press the [Tray Paper Settings] tab, and then press [Printer Bypass Paper Size].
D Select the paper size.
E Press [OK].
F Press the {User Tools/Counter} key.
The initial screen appears.
Note
❒ When loading translucent paper or film, set paper size and paper type.
❒ For printer driver settings, see the printer driver Help.
ATW003S
To Next Page
Loading...
Need help?
General
