Print Settings for GL/2 & TIFF Filter
111
4
General Settings
Specify basic print settings.
❖ Paper Tray Setting
Select which input tray to use for printing. If you select “Auto Paper Select”
the machine automatically selects an input tray based on the paper size and
type specified by the job.
❖ Margin Tolerance
Specify an area of allowance for the gap between the print area and the paper
size when using “Auto Paper Select”.
❖ Output Exit
Specify the output tray for printed paper.
❖ Auto Tray Switching
Enables the machine to switch automatically from an emptied paper tray to
another tray that contains the same size, orientation, and type of paper, with-
out interrupting the job.
❖ Paper Type
Select a paper type.
❖ Cut Method
Select the paper cut method. When roll paper is selected for input tray, the cut
method is enabled.
•Preset Cut
Cuts the roll paper to a standard size that fits the width of the print area. If
there is no appropriate standard size (for data such as long plots, etc.), Syn-
chro Cut is applied.
•Synchro Cut
Cuts the roll paper to the length of the print area.
❖ Reduce / Enlarge
Specify a scaling mode to reduce or enlarge the print size of documents.
❖ Magnification Ratio
Specify the ratio when Magnification Ratio is selected for “Reduce / En-
large”.
❖ Directional Magnification mm
Specify the vertical and horizontal value when Magnification Ratio is selected
for “Reduce / Enlarge”.
To Next Page
Loading...
Need help?
General
