6. [Heater Setting]
Changes whether the heater is enabled/disabled as well as the temperature of the heater. See page 81
"Adjusting the Heater Temperature".
7. [Origin Setting/Cut]
Sets the printing origin and cuts media. During printing, it switches to [Job Status]. See page 79 "Changing
Print Origin", page 104 "Cutting Media".
8. Error message
The contents of errors such as abnormalities or warnings are displayed.
9. Remaining media display
The remaining amount of media and width is displayed. The remaining amount is displayed only when the roll
media is set.
10. Heater temperature display
See page 25 "Checking the state of the heater".
11. Offline/Online display
The machine is offline while in the print standby state, and is online during printing.
Checking the state of the heater
The temperature and state of each heater are displayed.
1. Current temperature
2. Set temperature
3. The cure heater has not reached the required temperature.
4. Heating in progress
5. The heater is disabled.
6. The heater reaches the set temperature.
Adjusting the Angle of the Control Panel
To improve usability, you can adjust the angle of the control panel.
Guide to the Names and Functions of the Machine's Control Panel
25
To Next Page
Loading...
Need help?
General