1. Media
2. Post-heater
3. Pre-heater
4. Adjust according to the pre-heater scale.
5. The value when placed in a straight line.
Do not try to adjust the media to zero by force.
When setting roll media
The scale on the pre-heater can be used for checking the misalignment at the edge of the media
when loading the media. If the edge of the media is out of the range of the scale, move the roll
holder to adjust the position. Load the media from the paper feeding port, making sure that the
media is stretched evenly. Be sure to load the roll media with the post-heater scales aligned with
the pre-heater scales.
When setting leaf media
Use the 0 position on the scale of the post-heater as a guide for setting the edges of the media.
Setting Roll Media
• Do not leave the media with the heater ON for a long time.
This section explains how to set roll media. Set roll media while the machine's power is turned on.
If media has already been set, see page 68 "Changing Roll Media".
• Place the media so that it is positioned correctly relative to the arm near the cutter.
• If you touch the cutter part, the arm near the cutter may close. If this happens, move the media to a
position unreachable by the cutter, and then execute [Origin Setting / Cut] to cut.
2. Basic Operations
52
To Next Page
Loading...
Need help?
General