3. Make sure [Immed. TX] is not highlighted.
4. Place the original into the ADF.
5. Configure the scan and transmission settings in [Send Settings].
6. Specify a destination.
You can enter the destination's number or address directly or select from the Address Book by
pressing the destination key.
If you make a mistake, press the [Clear] key, and then enter again.
7. When sending the same original to several destinations (broadcasting), specify the next
destination.
8. If you send documents to Internet Fax or e-mail destinations or enable the Email TX
Results function, specify a sender.
9. Press the [Start] key.
Sending Originals Using the Exposure Glass (Memory Transmission)
1. Make sure [Immed. TX] is not highlighted.
2. Place the first page of the original face down on the exposure glass.
3. Specify a destination.
4. Make the scan settings you require.
5. Press the [Start] key.
6. Place the next original on the exposure glass within 60 seconds when you send multiple
originals, and then repeat steps 4 and 5.
Repeat this step for each page.
4. Fax
76
To Next Page
Loading...
Need help?
General
