Rigol DS6062-DEMO User Manual

RIGOL 13 System Function Setting
13-2 DS6000 User’s Guide
Remote Interface Configuration
DS6000 can communicate with PC via LAN, USB and GPIB (with the USB to GPIB
interface converter of RIGOL) buses. Please refer to the introduction below to
configure the corresponding interface before using the remote interfaces.
LAN Setting
Press UTIL  IO Setting  LAN Set to open the LAN setting interface. You can
view the network connection status and configure the network parameters.
Network Status
Connect the oscilloscope to your local area network using the network cable. The
LAN interface of the oscilloscope is on the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
 Net Config Success!
 Acquire IP…
 IP Conflict!
 Unconnected!
 DHCP Fail!
Network Status
Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status

Rigol DS6062-DEMO Specifications

General

Brand	Rigol
Model	DS6062-DEMO
Category	Test Equipment
Language	English