Rockwell Automation Publication 750-PM101B-EN-P - April 2022 89
Chapter 4 Troubleshooting
HIM Indication (Fault
Display Screen)
The popup fault display screen automatically appears when the drive detects a
fault condition for the host drive or any connected peripheral. By default, the
status bar flashes to alert the operator. To change the display flash mode, see
the PowerFlex 20-HIM-A6 and 20-HIM-C6S HIM User Manual, publication
20HIM-UM001
, for instructions.
The fault display screen displays the following information.
• Fault Code number (See Fault and Alarm Display Codes
on page 102.)
• Fault description
• Elapsed time (in hh:mm:ss format) from fault detection
Figure 66 - Pop-Up/Flashing Fault Display Screen
Manually Clearing Faults
Soft Key Functions
Label Name Description
ESC Escape Reverts back to the previous screen without clearing the fault.
CLR Clear Removes the pop-up Fault Display screen from the display and clears the fault.
Single Function Key
Key Name Description
Stop Removes the pop-up Fault Display screen from the display and clears the fault.
Stopped
0.00 Hz
AUTO
Fault Code 81
Port 1 DPI Loss
Elapsed Time 01:26:37
ESC
F
CLR
– – FAULTED – –
Step Key(s)
1. Press the ‘Clear’ soft key to acknowledge the fault. The fault information is removed so that you
can use the HIM.
2. Address the condition that caused the fault.
The cause must be corrected before the fault can be cleared.
3. After corrective action has been taken, clear the fault by one of these methods:
Press Stop (if running the drive will stop)
Cycle drive power
Select the ‘Clear’ soft key on the HIM Diagnostic folder Faults menu.
To Next Page
Loading...
Need help?
General
