Roland Jupiter-80 User Manual

Editing a Synth Tone
67
Introduction Playing Sounds Editing Sounds
Other Convenient
Functions
Connecting Other
Equipment
Appendix
• If a Synth Tone has been edited, a check mark (yellow) is shown
at the right of the tone name.
Volume and On/O Settings for Each
Partial
You can turn a Partial on/o by touching the <Partial SW>.
By touching <Partial SELECT> you can select the Partial that you
want to edit.
<Partial SW> Status
Lit red On
Unlit O
<Partial SELECT> Status
Lit green Selected
Unlit –
MEMO
• You can select two or more Partials by holding down the [SHIFT]
button and touching <Partial SELECT>.
• When the Synth Tone Edit screen is displayed, you can use the
PART BALANCE area of the panel to turn the three Partials on/o
and adjust their volume.
Turns each Partial
on/o.
Controls the AMP level
of each Partial.
The AMP level of each
Partial is shown by the
level meter.
• By holding down the [SHIFT] button and pressing the PART
[PERC ON/OFF], [LOWER ON/OFF], or [UPPER ON/OFF] buttons,
you can select the Partial that you want to edit.
PART button Selected Partial
PART [PERC ON/OFF] Partial 1
PART [LOWER ON/OFF] Partial 2
PART [UPPER ON/OFF] Partial 3
• To edit two or more Partials, simultaneously hold down the PART
buttons of the Partials that you want to edit.

Roland Jupiter-80 Specifications

General

Pitch wheel	Yes
Product type	Digital synthesizer
Product color	Black
Sound effects	Reverberation
Keyboard number of keys	76
Maximum polyphony (notes)	256
Headphone outputs	1
USB ports quantity	2
6.35 mm (1⁄4-inch) output	6
Display type	LCD
Power source type	AC

Weight and Dimensions

Depth	439 mm
Width	1231 mm
Height	140 mm
Weight	17700 g