Placement and Setup
20
Disconnecting Backup Power
Follow the steps below to disconnect the external power unit.
1. While keeping the lock switch on the adapter cable (XLR4
end) connected to the S-240P depressed, detach the cable
from the EXT. POWER DC INPUT connector.
2. While holding the lock switch on the S-240P's DC OUTPUT
plug pulled back, twist counterclockwise.
3. Detach the DC OUTPUT plug on the S-240P from the
adapter cable (Speakon end).
Turning the Power On and O
* Before turning the unit on/o, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/o. However, this is normal
and does not indicate a malfunction.
Turning the Power On
* Once everything is properly connecte be sure to follow
the procedure below to turn on their power. If you turn on
equipment in the wrong order, you risk causing malfunction or
equipment failure.
1. Turn on the power to any equipment connected to audio
inputs on the M-5000 or on any input/output units (S-
2416, S-4000S, or the like) connected to the M-5000.
* Acoustic feedback could be produced depending on the
location of microphones relative to speakers. This can be
remedied by:
5 Changing the orientation of the microphone(s).
5 Relocating microphone(s) at a greater distance from speakers.
5 Lowering volume levels.
2. Turn on the [POWER] switch on the M-5000.
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after turning the unit on is required before it will
operate normally.
3. Turn on the power to the external power unit connected
to the EXT. POWER DC INPUT connector on the M-5000.
4. Turn on the power to the input/output units.
5. Turn on the power to any equipment connected to audio
output on the M-5000 or on any input/output units.
Turning the Power O
1. Go to the MUTE GROUP MASTER window and tap <MUTE
ALL OUTPUTS> to mute audio output on the M-5000 and
on any input/output units (S-2416, S-4000, or the like)
connected to the M-5000.
0
“Muting All Outputs” (p. 60)
2. Turn down the output and turn o the power to any
equipment connected to audio output on the M-5000 or
on any input/output units.
3. Turn o the power to the external power unit connected
to the EXT. POWER DC INPUT connector on the M-5000.
* If an external power Unit is providing power to the M-5000, the
M-5000 will keep operating even if the power switch is in the
OFF position.
4. Turn o the [POWER] switch on the M-5000.
5. Turn o the power to the input/output units.
6. Turn o the power to any equipment connected to audio
input on the M-5000 or on any input/output units.
* To prevent malfunction and equipment failure, always turn
down the volume, and turn o all the units before making any
connections.
* If you need to turn o the power completely, rst turn o the
unit, then unplug the power cord from the power outlet. Refer
to “To completely turn o power to the unit, pull out the
plug from the outlet” (p. 4).
To Next Page
Loading...
Need help?
General
