Part Names and Functions
30
Assignable Fader Section
This section lets you assign any four channels you choose. This makes it possible to keep important channels at the top panel at all times.
For details, refer to the "Assignable Fader Section" in the Reference Manual (PDF).
Fader Bank display
[SEL] button
[SOLO] button
Level meter
[MUTE] button
Fader
Name Description
Fader Bank display
This displays information such as the input channel/output bus name and fader value. In the Function mode, it displays
information such as a list of functions and parameter values.
[SEL] button
This selects the input channel/output bus and selects the display target. In the function mode, it selects the function
and manipulates parameters.
[SOLO] button This turns solo on and o for the input channel/output bus.
Level meter This displays the signal level of the input channel/output bus.
[MUTE] button This turns muting on and o for the input channel/output bus.
Fader This operates the fader for the input channel/output bus.
USB MEMORY Connector
The M-5000 can use a USB ash drive to store and load a variety of data.
5 Project les
0“Saving a Project File to a USB Flash Drive” (p. 59)
0“Loading a Project File from a USB Flash Drive” (p. 60)
5 Recording and playback of WAV les using a USB memory recorder
0“Recording/Playback to/from a USB Flash Drive” (p. 58)
NOTE
* Never turn o the power or disconnect the USB ash drives when the access lamp of USB ash drives are lit or blinking
* Carefully insert the USB ash drive all the way in—until it is rmly in place.
* Some USB ash drive types or USB ash drives from some manufacturers may not record or play back properly on the USB ash drive.
* All USB ash drives eventually wear out. We recommend that you consider the USB ash drive not as a permanent storage site, but as a place to
store data temporarily. We also recommend that you back up important data onto the another media that is supported by your unit.
MEMO
5 Before using USB ash drives for this unit, please format the USB ash drives on this unit.
0“Formatting a USB Flash Drive on the M-5000” (p. 60)
5 Some USB ash drives might not be able to be used on this unit. If an error message appears when formatting as described in “Formatting a USB
Flash Drive on the M-5000” (p. 60), it is not possible to use for this USB ash drive with M-5000.
5 The M-5000 supports only USB ash drives (USB ash Memory and USB memory). Hard Disk and Memory Card Reader via USB are not supported.
5 USB ash drives do not work via USB hub.
To Next Page
Loading...
Need help?
General
