2-2 Printer Preparations
Making the Printer Settings and Loading Media
When Using Transparent Media
When you're using transparent media, make the necessary printing settings on the printer and load the media
accordingly.
Procedure
In the menu of the printer, set [EDGE DETECTION] to "DISABLE."
Load media (transparent media or transparent media with adhesive) into the printer.
When the media warps or partially oats, ensure a margin of about 200 mm from the leading edge of the
media to the printing- or cutting-start location.
Be sure to use the media clamps when you load media.
When Using Media Other Than Transparent Media
Load the media using the method described in the User's Manual of your printer.
VS-640i_USE2_EN_R1.indb 11 2013/07/23 19:00:24
To Next Page
Loading...
Need help?
General
