AdEM™-PTZ
ROMET LTD. 18
5. SET UP
The Setup Mode is employed to alter the factory default configuration of the AdEM®-PTZ program parameters to
match the individual specifications of each customer. The AdEM®-PTZ module would normally be shipped from
Romet with the Setup configuration fully programmed to a customer's specifications. The exception would be an
order for a loose AdEM®-PTZ module where the customer may not have specified the meter type. In such an
instance, the meter type and some of the associated parameters would need to be programmed by the customer
during the installation of the AdEM®-PTZ module to the meter body. Access to Setup Mode is protected by a sealable
En/Dis Jumper (switch) and a password (refer to section 4, SECURITY). The flow chart on the following pages
provides a guide to accessing and programming the Set Up mode using Keypad. The same parameters and more can
be changed by Software Setup.
To Next Page
Loading...
Need help?
General