AdEM®-PTZ
ROMET LTD. 78
AdEM®-PTZ CUSTOM DISPLAY CONFIGURATION OPTIONS
Listed below are the available parameters that can be programmed for custom display:
UNC VOL COR PULSE VOLUME LAST SAVED TIME
HIGH RESOLUTION UNC VOL OUTPUT PULSE SPACING UNC SINCE MALF
COR VOL BASE TEMP SERIAL #
HIGH RESOLUTION COR VOL BASE PRES FIRMWARE VERSION
DISPLAY TEST DATE PRESSURE TRANSDUCER RANGE
BATTERY LIFE TIME PRES TRANS SERIAL #
BATTERY VOLTAGE UNC FLOW RATE CASE TEMP
BATTERY INSTALL DATE COR FLOW RATE PREVIOUS DAY UNC VOLUME
METER SIZE UNC PEAK FLOW PREVIOUS DAY COR VOLUME
DISPLACEMENT VALUE UNC PEAK FLOW DATE DAILY UNC VOLUME
GAS TEMP UNC PEAK FLOW TIME DAILY COR VOLUME
TEMPERATURE FACTOR BAT MALFUN DATE UNC IN PROVING
GAS ABSOLUTE PRES TEMP MALFUN DATE BACKUP INDEX COUNTER
GAS GAUGE PRES TEMP MALFUN TIME OUTPUT PULSE WIDTH
ATMOSPH. PRES PRES MALFUN DATE SPEC GRAV (NX19, AGA8-G1, AGA8-G2, SGERG88)
PRESSURE FACTOR PRES MALFUN TIME MOL% N
2
(NX19, AGA8-G2)
SUPER-X FACTOR LAST SAVED UNC VOL MOL% CO
2
(NX19, AGA8-G1, AGA8-G2, SGERG88)
TOTAL COR FACTOR LAST SAVED COR VOL MOL% H
2
(SGERG88 only)
UNC PULSE VOLUME LAST SAVED DATE Hs (SGERG88 and AGA8-G1)
Note: Maximum of 15 selections from the list.
These parameters are configured in setup (by software only) under names: “Customer Display 1”
“Customer Display 2”
“Customer Display 3”
“Customer Display 4”
“Customer Display 5”
“Customer Display 6”
“Customer Display 7”
“Customer Display 8”
“Customer Display 9”
“Customer Display 10”
“Customer Display 11”
“Customer Display 12”
“Customer Display 13”
“Customer Display 14”
“Customer Display 15”
To Next Page
Loading...
Need help?
General