AdEM™-PTZ
ROMET LTD. 25
Setup by Software
Most of Setup parameters can be change only by software, contrary to most of previous Romet products where
complete Setup was fully or almost fully available through keyboard operation. Under RometLink’s Talk to
Unit/Setup drop down menu, there are available the following options:
✓ Configure Default set of parameters
✓ Configure Customer Display list of parameters
✓ Configure predefined or user defined Group of parameters
✓ Configure single parameter
Fig.13 Setup window
Access to configuration of default set of parameters is available also using Toolbar Talk: Setup button.
There are three types of parameters under software setup:
✓ Read only- Parameter Cannot be modified
✓ Read/Write – Read Only after Sealing (Program Switch in “Disable” position)
✓ Read/Write – Parameter can be freely modified with or without protection by Event Logger.
There are available approx. 161 parameters which can be read or “read and Write” under the software Setup.
This number includes 21 AGA8 Gas Components which can be modified as a separate group of parameters.
Modifications are protected by password.
For list of parameters see the following Table 2 and Fig. 13a.
To Next Page
Loading...
Need help?
General