USER'S AND
MAINTENANCE
MANUAL
01/31/2020
Air Compressor : D185T4F-DB
Copyright © 2014, ROTAIR S.P.A. - All rights reserved. This manual is intellectual property of ROTAIR S.PA.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
5 LEVELS AND QUALIFICATIONS OF THE PERSONNEL
The operation, service, and maintenance of the machinery must be performed by qualified, trained,
and informed personnel only. "Qualified personnel" means people who, based on their
profession, have acquired experience and instructions as well as knowledge on the relevant
standards and recommendations on accident prevention and operational conditions. Such
personnel, appointed by the machinery safety managers, must be able to perform the
required operations as well as recognize and anticipate the potential hazards.
Entrust the activities to appropriately trained or instructed personnel only; determine unmistakably the
competence of personnel as related to the fine-tuning and the maintenance and repair activities. Define the
responsibility of the operators appointed to run the equipment through accurate written recommendations
and authorize them to reject recommendations by third parties if in conflict with the safety regulations and
standards of the machine manufacturer. Ensure that the activities are performed by purposely-appointed
personnel only. The actions on the electrical equipment of the machinery can be performed in compliance
with the electro-technical regulations and standards by qualified electricians or by people with an appropriate
level of competence in the electro-technical field. The mechanical and pneumatic maintenance can be
performed by the technicians of the authorized service centers.
6 SAFETY RECOMMENDATIONS
6.1 Safety provisions concerning transport
The air compressors that are not certified for towing need to be loaded onto another means of transport.
The air compressor has to be attached appropriately to the loading deck of the transport vehicle in such a
way to prevent an unbalancing of the load during transport.
The unit is shipped by ROTAIR and attached to a support appropriate for its handling by means of fork-
lift trucks; such wooden platforms facilitate the anchorage to the loading deck of the transport vehicle
and prevents the load from sliding.
For safe transport, operate as follows:
1) Make sure the tie-downs pass over the air compressor and tighten them by means of the winches provided
with the means of transport.
2) Set blocks or wedges on all sides of the air compressor, attaching them to the loading deck of the vehicle
in order to prevent the machinery from moving.
3) Travel at moderate speeds.
To Next Page
Loading...
Need help?
General
