Rotair Dustless Blasting D185T4F-DB User Manual

USER'S AND
MAINTENANCE
MANUAL
Date:
01/31/2020
Code
MAN D185T4F-DB
ENG
Air Compressor : D185T4F-DB
Revision
03
Copyright © 2014, ROTAIR S.P.A. - All rights reserved. This manual is intellectual property of ROTAIR S.P.A.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
Page
43/59
13 MAINTENANCE
The machine must be receive regular periodic maintenance in order to provide safe, adequate,
and uninterrupted service. Maintenance work must be performed by qualified personnel that
have been properly trained to operate and service the machine. Most maintenance and
service will be performed with the machine stopped and the power switched off on the
electrical panel.
The maintenance and service technicians must check that they have removed their tools at
the end of service and before starting the machine again to avoid damage to the moving parts.
13.1 Routine maintenance
The sole objective of routine maintenance is to restore a system (or one of its components) from a state of
failure or non-optimal operation to the state that it is performing as it was before the onset of the problem.
In the following chapter are listed in order of frequency all operations concerning the compressor and the
engine. It will be necessary to refer to OPERATING AND MAINTENANCE, which is prepared by the
manufacturer of the engine and is supplied with the machine.

Rotair Dustless Blasting D185T4F-DB Specifications

General

Brand	Rotair
Model	Dustless Blasting D185T4F-DB
Category	Air Compressor
Language	English