USER'S AND
MAINTENANCE
MANUAL
01/31/2020
Air Compressor : D185T4F-DB
Copyright © 2014, ROTAIR S.P.A. - All rights reserved. This manual is intellectual property of ROTAIR S.P.A.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
1.3
General technical standards
The machinery has been designed and developed in compliance with the recommendations contained in the
technical standards reported below.
Safety of machinery - General design principles - Risk assessment and
risk reduction.
Safety of machinery - Safety distances to prevent from reaching
the hazardous areas with the upper or lower limbs.
Safety of machinery - Emergency stop system, functional aspects
Safety of machinery - Functional safety of the programmable electrical and
electronic control systems as related to safety
Safety of machinery - Electrical equipment of the machineries. Part I:
General rules.
Safety of machinery - Safety requirements relevant to systems/related
components for hydraulic and pneumatic transmission - Pneumatics
Safety of machinery - Minimum openings to prevent the crushing of parts
of the human body
D. LGS. January 27th 2010
no.17
Implementation of Directive 2006/42/CE relevant to machinery, which
modifies directive 95/16/CE relevant to elevators
Safety of machinery - Risk assessment - General principles
Safety of machinery - Examples
Machine directive 2006/42/CE.
Article 7. Presumption of conformity and general standards
1. The Member States deem that the machinery provided with the “CE” marking and accompanied by the CE
declaration of conformity, whose elements are provided for in Annex II, Part 1, Section A, comply with the
provisions of this directive.
2. The machinery manufactured in compliance with an authorized standard, whose reference has been
published in the Official Journal of the European Union, is assumed to be compliant with the essential
health and safety requirements covered by such harmonized standards.
3. The Commission published the references of the harmonized standards in the Official Journal of the
European Union.
4. The Member States shall take the appropriate measures to allow the social partners influencing—at the
national level—the development and control processes of the general standards.
To Next Page
Loading...
Need help?
General
