Rotair Dustless Blasting D185T4F-DB User Manual

USER'S AND
MAINTENANCE
MANUAL
Date:
01/31/2020
Code
MAN D185T4F-DB
ENG
Air Compressor : D185T4F-DB
Revision
03
Copyright © 2014, ROTAIR S.P.A. - All rights reserved. This manual is intellectual property of ROTAIR S.P.A.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
Page
30/59
8.3 Fuses
The fuse is an electrical device which can protect a circuit or a device from excessive current. The fuse
consists of a cartridge provided by a thin lead wire through which the rated current of the circuit travels; this
wire is the actual fuse, with a precise amperage load capability. In case of excessive current, the filament
melts and causes the circuit to open.
Fuse holder
Fuse
Description
Ampere
Secondary fuse: device to protect against
excessive current which might damage the
fuel solenoid
16 A
Operator Panel Fuse: protection device
against excessive current that may damage
the operator's control panel
40 A
Glow plug fuse: Protection device against
excessive current that could damage the
engine
40 A
WARNING: When replacing the fuses, we recommend always utilizing the same type and
rating as indicated in this table and following the procedures reported in Section 13.4-3
of the manual.

Rotair Dustless Blasting D185T4F-DB Specifications

General

Brand	Rotair
Model	Dustless Blasting D185T4F-DB
Category	Air Compressor
Language	English