Settings
Section 2B. Your Device’s Settings 41
Call Alert Notification
Your device can alert you with an audible tone when
you change service areas, once a minute during a
voice call, or when a call has been connected.
1. Press Start > Settings > Sounds > Call Alert.
2. Select Minute beep, Connect tone, or Signal fade tone.
3. Select On or Off for each category and press Done
(left softkey).
Selecting an R2VS Setting
R2VS™ significantly enhances the quality of mono and
stereo audio by simulating stereo sound through a
connected headset, thereby creating improved
dynamics and bass performance. R2VS provides
panoramic three-dimensional audio that extends the
sound beyond the speakers or headphones
themselves. These enriching effects are especially
noticeable on digitally compressed audio formats such
as MP3 and WMA.
To utilize this feature, your device needs to be
connected to a headset via the Power/Accessory
Interface Connector.
1. Press Start > Settings > Sounds > R2VS.
2. Use your navigation key to scroll through the
available stereo settings.
䡲 Choose None (Mono), 3D Sound, or M-Theater.
3. Press Done (left softkey) to assign a setting.
Assigning Sound Profiles
Using profiles, you can adjust and customize device
tones for different events or environments and then
apply the settings as a group. The currently selected
profile is displayed in the upper-right section of the
Home screen.
1. Press Start > Settings > Profiles.
2. Select Normal, Silent, Vibrate, Outdoor, or Automatic
and press
Done (left softkey).
Tip
You can quickly change the profile by briefly pressing
and then releasing the
key. Select the profile you
want from the Quick List and press .
You can quickly activate or deactivate the Silent profile
by pressing and holding
from the Home screen.
I325.book Page 41 Tuesday, December 11, 2007 11:23 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
