85
Setting Power Save
The Power Save function allows you to set an idle time after
which the camera automatically sets to sleep mode to save
power. After a minute of being in sleep mode, the camera
eventually turns off power.
Available setting: 1 min., 3 min., 5 min., Off.
This function is not available in the following instances:
• Recording a video or audio file
• Playing a slideshow/video/audio file (Exclude pause)
• Using the USB connector
Setting LCD Save
Enable the LCD Save function to automatically decrease the
LCD brightness to conserve battery power. When the
camera is idle for 20 seconds, the LCD darkens. Press any
button to resume to normal brightness.
• The camera is idle when no buttons are pressed. LCD
Save, though enabled, does not function during video
playback, slideshow, video recording and
Pre-Composition scene mode shooting.
Setting Date & Time
Use the Date & Time function to set the date and time of
your camera. This function is useful in attaching date
stamps on captured images. Your camera uses a 12-hour
time format. Please refer to "Initial Settings" on page 21 to
know about how to configure the settings.
To Next Page
Loading...
Need help?
General
