satoh BULL S-630 User Manual

All components of SATOH tractors model S-630 & S-6300 are subject
to stringent checking during assembly in the factory. However, a new
tractor should be carefully checked over by the operator himself. For the
first 25'" 50 hours operation, heavy duty work should be avoided. If
heavy duty work is unavoidable, drive in a gear one stage lower than you
would normally use, and run the engine at lower speed.
After the first 50 hours running,
the following service, maintenance and
checking should be carried
out.
(1) Replace the oil filter and engine oil.
(2) Replace the transmission oil and clean the hydraulic oil filter.
(3) Retighten
all bolts and nuts.
(4) Check and adjust the fan belt tension.
(5) Check
the wheels to see if their condition is good and tire pressure is
correct.
(6) Retighten
the cylinder head bolts and adjust valve clearances.
This 50-hour Service
is an essential procedure for keeping the tractor in
top condition, so it must be done properly.
-2-

satoh BULL S-630 Specifications

General

Brand	satoh
Model	BULL S-630
Category	Tractor
Language	English