22
SCClub operating instructions
Commissioning
3.1 Installation location
• The installation location must be dry and
protected from spray water.
• Water, condensation or steam can always
escape from a coee machine.
> Do not use the coee machine in the open.
> Set up the coee machine so that it is
protected from spray water.
> Make sure to set the coee machine on
a water-resistant surface which is not
sensitive to heat to protect the installation
surface from damage.
3.2 Unpacking
> The packaging material in the box contains
accessories. Do not throw away.
> The water tank and the grounds container
contain spare parts. Remove the spare
parts before commissioning and thoroughly
rinse the grounds container and the water
tank.
> Check whether the coee machine is
intact. In case of doubt, do not put the
coee machine into operation and contact
Schaerer Service.
> Therefore, be sure to keep the original
packaging in a safe place should a return
delivery be necessary.
Option double powder
The optional double powder container is sent
in separate packaging. If the coee machine
is equipped with this option, the double
powder container must be mounted before
commissioning the coee machine. Operating
without the container mounted is not permitted.
IMPORTANT
Observe the Warranty chapter
wfrom page 106
Technical data
wfrom page 107
IMPORTANT
Observe the Warranty chapter
wfrom page 106
Accessories and labelling of
machine parts
w page 17
Technical data
wfrom page 107
IMPORTANT
Chapter Warrenty
w from page 106
Technical data
w from page 107
To Next Page
Loading...
Need help?
General
