80
SCClub operating instructions
Care
7.6.5 Cleaning the drip tray
Danger of scalding
• Hot liquids could be in the drip tray.
• If the drip tray does not correctly engage,
for example after cleaning, there is a risk of
burns from hot uids.
> Carefully move the drip tray.
> Reinstall it carefully so that no unintended
water leakage occurs.
> Always make sure the drip tray is
positioned correctly.
* Carefully life and remove the drip tray from the
front
* Remove the drip grid and clean with the cleaning
brush
* Thoroughly clean the drip tray
* Thoroughly clean the SteamJet outlet and cover
with the supplied cleaning brush
* Then rinse the drip tray and drip grid with pure
drinking water
* Dry the drip tray and drip grid, put them together
and reinsert
The underside of the drip tray and the area
of the drip tray sensor must be dry before
insertion. The sensor is located on the right
under the drip tray.
If moisture remains in this area, the “Empty
drip tray” message appears again.
CAUTION
Observe the Safety chapter
w from page 9
IMPORTANT
To Next Page
Loading...
Need help?
General
