User manual SCA - EN
Version 02 09.2006
Safety noteswww.schaerer.com
46
Safety notes
User at risk
Maximum safety is one of M. Schaerer AG’s most important product features. The effectiveness
of the safety devices is only ensured as long as the following is observed:
• Read the user manual carefully before using the device!
• Do not touch any hot machine parts!
• Do not use the coffee maker if it is not functioning optimally or is damaged!
• Keep children away from the coffee machine!
• Under no circumstances may the installed safety devices be modied!
Please comply with the following instructions when handling the coffee maker in order to
prevent injuries or health hazards:
Risk of scalding!
There is a risk of scalding in the area where coffee, hot water and steam are dispensed.
Never reach under the outlet while a beverage is being dispensed!
Risk of burns!
The brew unit may only be cleaned when the coffee maker is cold.
The brew unit can become hot.
Risk of squeezing!
There is risk of squeezing ngers or hands when handling moving components!
While the coffee maker is switched on, never reach into the bean containers or into the
opening of the brew unit!
Health hazard!
The bean containers and the manual slot may only be lled with the materials intended for use!
Health hazard!
When handling cleaning agents and decalcifying products, follow the safety measures on the
packaging. Cleaning agents and decalciers are irritants. Do not insert the cleaning agent or
solution with decalcier until a request appears on the display asking you to do so.
Risk of irritation and burns!
Never reach under the outlets during a cleaning cycle or during beverage output!
Cleaning uid and hot beverages come out of the combination outlet during cleaning cycles
and beverage output.
Caution, electrocution!
Only skilled electricians may carry out work on electrical systems!
The device must be connected to a secured circuit!
All relevant guidelines on low voltage and/or country-specic or local safety regulations and
laws must be observed.
We recommend using an earth leakage circuit breaker in the connection.
The connection must be grounded according to regulations and safeguarded against
electrocution.
The voltage must correspond to the data on the device’s serial plate.
Never insert the power plug into the socket while it is wet or touch it with wet hands!
Never touch energized parts!
Before carrying out service work, always switch off the main switch and/or disconnect the
device from the power supply system.
The power cord may only be replaced by a qualied service technician.
When choosing cleaning products, please pay attention to its environmental friendliness, health
risks, disposal requirements and any local options for proper disposal.
To Next Page
Loading...
Need help?
General
