EasyManua.ls Logo

Segway x2 SE Service Manual

Segway x2 SE
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Segway Personal Transporter SE Service Manual
3–2
Batteries
When replacing a Battery, consider replacing both Batteries,
and always use pairs of Batteries with the same chemistry.
Replacing only one Battery will not necessarily increase the
performance or range of the PT, because the PT is designed to
operate only at the level allowed by the lower-energy Battery.
Redundancy is a critical safety feature built into the Segway
PT that also applies to the Batteries. Therefore, you should
replace Batteries in pairs (except for the unusual situation
where a Battery is replaced because of damage or defect and
the other Battery is relatively new).
NOTICE
To isolate a problem in a specific battery, swap front and
rear Batteries to confirm that the error condition follows the
Battery.
Removal
Tool Required: 3 mm hex wrench
1. Make sure the PT is powered off and unplugged.
2. Tip the PT onto its side so the Wheel lies flat against
a smooth, clean surface.
3. Using a 3 mm hex wrench, remove the battery
fasteners (4 per battery). See Figure 3–1
4. Pull the Battery straight off the chassis.
5. Repeat steps 3 and 4 for the other Battery.
NOTICE
Consult your local recycling center for proper disposal of
Batteries.
Batteries
Figure 3–1: Battery Removal
Battery

Other manuals for Segway x2 SE

Questions and Answers:

Segway x2 SE Specifications

General IconGeneral
Max Speed12.5 mph (20 km/h)
Weight Capacity260 lbs (118 kg)
BatteryLithium-ion
Weight120 lbs (54 kg)
Charging Time8 hours
Water ResistanceIP54

Summary

Copyright, Disclaimer, Trademarks, Patent, and Contact Information

Trademarks and Patents

Information on Segway's registered trademarks and patent coverage.

Contact Information

Provides Segway customer care contact details and website for support.

General Safety Precautions

Safety Conventions and Notices

Defines safety messaging conventions and provides important safety notices.

Specific Safety Guidelines

Covers safety for fasteners, eye protection, ESD, solvents, and general questions.

Introduction to Segway PT Service

Manual Purpose, Audience, and Certification

Outlines the manual's purpose, target audience, and certification requirements.

Manual Organization and Chapter Overview

Describes the manual's structure and provides a summary of chapter contents.

Terminology and User Materials

Defines terms and lists related user materials for service.

Parts Diagram

Illustrates and labels various components of the Segway PT.

LeanSteer Assembly Service

Standard LeanSteer Frame Components

Details components of the standard LeanSteer frame.

Patroller LeanSteer Frame Components

Details components of the patroller LeanSteer frame.

Handlebar Removal and Installation

Instructions for removing and installing the handlebar assembly.

LeanSteer Frame Removal and Installation

Instructions for removing and installing the LeanSteer frame.

LeanSteer Stem Removal and Installation

Instructions for removing and installing the LeanSteer stem.

InfoKey Controller and Dock Procedures

Steps for removing and installing the InfoKey controller and dock.

InfoKey Controller Battery Replacement

Procedure for replacing the battery in the InfoKey controller.

Segway PT Mats Service

Mat Removal and Installation

Instructions for removing and installing the rider mats.

Segway PT Batteries Service

Battery Removal

Procedure for removing the Li-ion batteries from the Segway PT.

Battery Installation

Procedure for installing the Li-ion batteries onto the Powerbase.

Segway PT Tire/Wheel Assembly Service

i2 SE Wheel Assembly Service

Instructions for removing and installing the i2 SE wheel assembly.

x2 SE Wheel Assembly Service

Instructions for removing and installing the x2 SE wheel assembly.

x2 SE Turf Wheel Assembly Service

Instructions for removing and installing the x2 SE Turf wheel assembly.

x2 SE Turf Hub Adapter Service

Procedure for removing and installing the x2 SE Turf hub adapter.

i2 SE Tire Tube Service

Steps for removing and installing the i2 SE tire tube.

Segway PT Fenders Service

i2 SE Fender Service

Instructions for removing and installing the i2 SE fender.

x2 SE Fender Service

Instructions for removing and installing the x2 SE fender.

x2 SE Fender Frame Service

Instructions for removing and installing the x2 SE fender frame.

Segway PT Powerbase Trim Service

Gearbox Cover Service

Procedure for removing and installing the gearbox cover on i2 models.

Console Cover Service

Steps for removing and installing the front and center console covers.

Front and Rear Fascia Service

Instructions for removing and installing the front and rear fascia.

Segway PT Gearbox Service

Gearbox Removal

Detailed steps for removing the gearbox assembly.

Gearbox Installation

Detailed steps for installing the gearbox assembly.

Segway PT Serviceable Powerbase

Establishing a Serviceable Powerbase

Defines the Serviceable Powerbase and lists components to remove/reassemble.

Segway PT Console Service

Console Components Overview

Diagram illustrating the various components within the console.

Radio Board Service

Instructions for removing and installing the radio board.

Console Removal and Installation

Steps for removing and installing the main console assembly.

Power Board Service

Instructions for removing and installing the power board.

Interconnect Board Service

Steps for removing and installing the interconnect board.

AC Input Filter Service

Instructions for removing and installing the AC input filter.

Pivot Assembly Service

Steps for removing and installing the pivot assembly.

Front Light Pipe Service

Instructions for removing and installing the front light pipe.

Segway PT Chassis Cover Service

Chassis Cover Removal

Procedure for removing the main chassis cover.

Chassis Cover Installation

Procedure for installing the main chassis cover.

Segway PT CU Board Service

CU Board Removal

Instructions for removing the Control Unit (CU) boards.

CU Board Installation

Instructions for installing the Control Unit (CU) boards.

Segway PT Balance Sensor Assembly Service

Balance Sensor Assembly Removal

Procedure for removing the Balance Sensor Assembly (BSA).

Balance Sensor Assembly Installation

Procedure for installing the Balance Sensor Assembly (BSA).

Segway PT Motor Service

Motor Removal

Instructions for removing the motor assembly.

Motor Installation

Instructions for installing the motor assembly.

Elastomer Bushing Service

Inspection, removal, and installation of the elastomer bushing.

Segway PT Powerbase Chassis Service

Powerbase Chassis Disassembly and Reassembly

Procedures for disassembling and reassembling the powerbase chassis.

Segway PT Post-Service Tests

Startup Test

Verifies proper power-on of the PT and InfoKey controller.

Standard Check Procedures

Checks fasteners, wheels, mats, and overall component security.

Operational Test

Tests rider detection, balance mode, and basic maneuverability.

Segway PT Parts List

Customer Replaceable Kits

Lists kits available for customer replacement of parts.

Technician Replaceable Parts

Lists parts intended for replacement by certified technicians.

Segway PT Fasteners Guide

Fastener Usage Warnings

Important warnings and guidelines for using Segway-approved fasteners.

Fastener Specifications Table

Detailed list of fasteners, their types, applications, and torque specs.

Segway PT Tools and Equipment

Recommended Tools for Service

Lists essential tools and equipment for servicing Segway PT.

Segway PT Glossary of Terms

Technical Term Definitions

Provides definitions for key technical terms used in the manual.

Related product manuals