1 Safety notes
■
Read the operating instructions before commissioning.
■
Connection, mounting, and setting may only be performed by skilled per‐
son.
■
Not a safety component in accordance with the EU Machinery Directive.
■
Power supply: Class 2
Enclosure type 1
■
When commissioning, protect the device from moisture and contamination.
■
These operating instructions contain information required during the life cycle of
the sensor.
2 Intended use
The GTE6V is an opto-electronic photoelectric proximity sensor (referred to as “sensor”
in the following) for the optical, non-contact detection of objects, animals, and persons.
If the product is used for any other purpose or modified in any way, any warranty claim
against SICK AG shall become void.
The GTE6V sensor complies with the Radio Safety Requirements (EMC) for the indus‐
trial sector (Radio Safety Class A). It may cause radio interference if used in a residen‐
tial area.
3 Operating and status indicators
Energetic photoelectric proximity sensor.
34.2 (1.35)
37.1 (1.46)
25.4 (1.0)
37.4 (1.47)
21.7 (0.85)
21.7 (0.85) 14.5 (0.57)
7.6 (0.3)
10.3 (0.41)
2
3
4
1
5
6
8
7
7.1
(0.28)
Figure 1: Connection type: cable
1
Mounting holes M3
2
Optical axis, receiver
21.7 (0.85)
34.3 (1.35)
43.2 (1.7)
43.5 (1.71)
21.7 (0.85)
14.5 (0.57)
25.4 (1.0)
7.6 (0.3)
7.1
(0.28)
10.3 (0.41)
2
3
4
1
5
6
8
7
Figure 2: Connection type: plug, M8
1
Mounting holes M3
2
Optical axis, receiver
SAFETY NOTES 1
8021850 | SICK
Subject to change without notice
5
To Next Page
Loading...
Need help?
General
