Siemens SCALANCE XR-500 User Manual

-40 °C to 40 °C

24 x SFP, Group1 8 x SFP, Group1
or
8 x SFP+, Group1
2 x RJ45
ports
10Gbps

Max. 2 of the SFP transceivers used in Group B can be from
SFPGroup2.
Max. 2 of the SFP
transceivers used in
Group C can be from
SFPGroup2.
The table below shows the assignment of the SFP transceivers to the speci󹪝ed groups.
Category Group Type Article number
SFP Group 1 SFP991-1 6GK5 991-1AD00-8AA0
SFP991-1 (C) 6GK5 991-1AD00-8FA0
SFP991-1LD 6GK5 991-1AF00-8AA0
SFP992-1 6GK5 992-1AL00-8AA0
SFP992-1LD 6GK5 992-1AM00-8AA0
SFP992-1LD (C) 6GK5 992-1AM00-8FA0
Group 2 SFP991-1LH+ 6GK5 991-1AE00-8AA0
SFP991-1ELH200 6GK5 991-1AE30-8AA0
SFP992-1+ 6GK5 992-1AG00-8AA0
SFP992-1LD+ 6GK5 992-1AM30-8AA0
SFP992-1LH 6GK5 992-1AN00-8AA0
SFP992-1LH+ 6GK5 992-1AP00-8AA0
SFP992-1ELH 6GK5 992-1AQ00-8AA0
SFP992-1BXMT 6GK5 992-1AL00-8TA0
SFP992-1BXMR 6GK5 992-1AL00-8RA0
SFP992-1BX10T 6GK5 992-1AM00-8TA0
SFP992-1BX10R 6GK5 992-1AM00-8RA0
SFP+ Group 1 SFP993-1 6GK5 993-1AT00-8AA0
SFP993-1LD 6GK5 993-1AU00-8AA0
Group 2 SFP993-1LH 6GK5 993-1AV00-8AA0
6.7 Signaling contact
The signaling contact is an event-driven or manually controlled failsafe alarm relay. Individual
alarms can be con󹪝gured to trigger the relay when the associated event occurs. The relay can
also be 󹪝xed in an open or closed state.
Manually controlling the relay may be useful to:
• Verify the failsafe relay is properly connected following the installation of the device
• Verify the open/close state is caused by the device itself or some other hardware
• Keep the relay in an open/close state while troubleshooting a network issue
Connecting up
6.7Signaling contact
SCALANCE XR-500
Operating Instructions, 07/2023, C79000-G8976-C692-01 81

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English