Start-Up
4.7 Commissioning
4-73
SINUMERIK 802C
6FC5 597–3AA20–0BP2 (01.02)
4.7 Commissioning
Initializing the control system
S Turn on the control system.
S The SINUMERIK 802C will load the standard machine data automatically.
4.7.1 Entering the general machine data
Overview
To make your work easier, the most important machine data of the individual subranges are
listed. If more detailed information is required, the user is referred to the relevant chapters/
sections of this manual. The machine data and interface signals are described in detail in the
descriptions of functions to which reference is made in the relevant lists.
Note
The general machine data are selected such (default values) that only a few machine data
parameters have to be modified.
Entering the machine data (MD)
Before the machine data can be entered, the password for protection level 2 or 3 must be ent-
ered.
The following machine data ranges must be selected and modified (if necessary) using the
appropriate softkeys:
S General machine data
S Axis machine data
S Other machine data
S Display machine data
To Next Page
Need help?
General
