Skoda OCTAVIA User Manual

Remove/insert cap
›
To remove, press on the cap in the direction of the arrow
1
and remove this
in the direction of arrow
2
» Fig. 342.
›
To insert, insert the cap in arrow range
1
and then press on the opposite
edge of the cap. The cap must engage firmly.
Removing/installing the towing eye
›
To install, screw in the towing eye by hand in the direction of arrow
3
» Fig. 342 until the stop» .
›
Tighten the towing eye using a wheel wrench or similar object. To do this,
insert the wheel wrench through the eye.
›
To remove, unscrew the towing against the direction of arrow
3
.
WARNING
The towing eye must always be tightened, otherwise the towing eye may
break during the towing.
Towing eye rear
Fig. 343
Remove cap / install towing eye - Variant 1
Fig. 344 Remove cap / install towing eye - Variant 2
Remove/insert cap
›
To remove, press on the cap in the direction of the arrow
1
and remove this
in the direction of arrow
2
» Fig. 343.
›
To insert, insert the cap in arrow range
1
and then press on the opposite
edge of the cap. The cap must engage firmly.
Removing/installing the towing eye
›
To install, screw in the towing eye by hand in the direction of the arrow
3
» Fig. 343» Fig. 344until it clicks into place» .
›
Tighten the towing eye using a wheel wrench or similar object. To do this,
insert the wheel wrench through the eye.
›
To remove, unscrew the towing against the direction of arrow
3
.
Vehicles with a tow hitch
For vehicles with factory-fitted towing device, at the back there is no mount
for a screw-in towing eye. Use the detachable ball rod for towing » page 255,
Hitch.
WARNING
The towing eye must always be tightened, otherwise the towing eye may
break during the towing.
298
Do-it-yourself

Skoda OCTAVIA Specifications

General

Brand	Skoda
Model	OCTAVIA
Category	Automobile
Language	English