HGM6000K Series Automatic Generator Module
HGM6000K Series Automatic Generator Module ISSUE 2011-06-20 Version 1.7 Page 5 of 34
Inactive power KVar
Apparent power KVA
Power factor Cos
Accumulate total gens power kWh
■ Mains have over voltage, under voltage, loss phase function; Gens have over
voltage, under voltage, over frequency, under frequency, over current function;
■ Precision measure and display parameters about Engine,
Temp. (WT), °C/ °F both are display
Oil pressure (OP), kPa/Psi/Bar all be display
Fuel oil level (FL), % (unit)
Speed (SPD), RPM (unit)
Voltage of Battery (VB) V (unit)
Voltage of Charger (VD) V (unit)
Hour count (HC) can accumulate Max. 999999 hours.
Starting up can accumulate Max.999999 times.
■ Control protection: Automatic crank/stop of diesel engine, load transfer(ATS
control) and completely faults display protection;
■ With ETS, idle control, pre-heat control, raises speed control functions, and all
types of them are belong to relay output;
■ Parameters setting: Allow user to modify setting and store them by inside
internal FLASH memory, the parameters cannot be lost even with power off. All
of parameters can be set not only from the front panel, but by PC via SG72 (an
adaptor, USB-LINK-RS485) module; or, through RS485 port via PC;
■ Most of temperature, pressure, oil level sensor can be directly used, and also
user can define sensor curve by themselves;
■ Multiple crank disconnection conditions can be selected.(Speed sensor, oil
pressure, gens);
■ Power supply range is wide(8~35)VDC, accommodating to different starting
battery voltage environments;
■ All parameters use digital modulation, abandoning analog modulation using
conventional electronic potentiometer, more reliability and stability;
■ Modular configuration design, Flame Retardant ABS plastic shell, inserted type
connection terminals, flush type installation, compact structure, easy
installation.
To Next Page
Loading...
Need help?
General
