HRX-OM-K003
Chapter 7 System Maintenance
HRW Series 7.3 Storage
6. Upon completion of fluid draining, close the valve of the tank drain port.
7. Add plugs to seal off ports on the rear of
this system.
See section 7.3.2 “Draining of facility water”
on pege 7-5 for plug attachment.
7.3.2 Draining of facility water
1. Place the drain pan underneath the
piping connections on the rear of this
system.
A 3L-capacity or bigger drain pan is required.
Figure 7-2 Plug Attachment
Figure 7-3 Drain Pan Attachment
Be sure to drain the facility water only when it is at room temperature.
Trapped fluid inside the system can still be hot. Potential burns can
occur if disregarded.
To Next Page
Loading...
Need help?
General
