S
WITCH
S
TATIC
C
ONFIGURATION
M
ENU
4-23
Configuring Tag-based VLANs
Use the VLAN Configuration menu to create tag-based VLANs.
Field Attributes
When the VLAN mode is set “802.1Q” or “802.1QwithGVRP” (on the
VLAN Configure page), the following attributes are displayed.
• PVID – VLAN ID assigned to untagged frames received on the port.
(Default: 1)
• Ingress Filter 1 (NonMember Pkt) – If ingress filtering is enabled,
incoming frames for VLANs which do not include this ingress port in
their member set will be discarded at the ingress port. (Default: Drop)
- Ingress filtering only affects tagged frames.
- If enabled, the port will discard incoming frames tagged for VLANs
which do not include this ingress port in their member set.
- If disabled, the port will accept any VLAN-tagged frame if the tag
matches a VLAN known to the switch.
- Ingress filtering does not affect VLAN independent BPDU frames,
such as GVRP or STP.
• Ingress Filter 2 (Untagged Pkt) – Sets the port to drop untagged
frames. If only tagged frames are accepted, the switch will only accept
frames if the frame tag matches a VLAN to which this port has been
assigned. (Default: Forward)
To Next Page
Loading...
Need help?
General
