A6T/A6/A5 Portable Ultrasonic Diagnostic System
4701-0040-01A
1-4
1.3 Biological safety
This product should be used only for valid reasons and should be used both
for the shortest period of time and at the lowest power settings necessary
(ALARA - As Low As Reasonably Achievable) to produce acceptable
diagnostically image.
1.4 Ultrasound Safety
Keep the transducers clean. The transducers shall be cleaned before
scanning another patient.
Patients should always be exposed to the lowest transmit power for the
shortest time. Freeze the system or keep the probe away from the patient if
no scanning is performed. Do not scan the patient with the probe at a fixed
position of the body for a long time; Please refer to Appendix C for acoustic
report of the system.
1.5 Operating Environment
¾ The unit should be operated within the parameter outline below:
z Relative humidity: 30％～75% non-condensing
z Ambient temperature: 10 ℃ ～ 40℃
z Atmosphere Pressure: 700～1060hPa
¾ Strong radiation source or powerful electromagnetic waves, e.g.
electromagnetic waves from radio broadcasting, may result in
image ghosting or noise. The system shall be isolated from such
radiation source or electromagnetic waves.
¾ Do not put anything on top of the main unit.
¾ When the system is not in use, be sure to turn off the power
supply. Cover the main unit with a dust cover. The system shall
be operated in the environment without dust.
To Next Page
Loading...
Need help?
General
